Ext-Community-Type - HP FlexNetwork 3600 v2 Series Command Reference Manual

Description
Use export route-policy to apply an export routing policy to a VPN instance.
Use undo export route-policy to remove the application.
By default, no policy is applied to filter the routes to be advertised.
You can specify an export routing policy when the VPN route advertisement control provided by the
extended community attributes is not enough. An export routing policy may deny routes that are
permitted by the export target attribute.
An export routing policy specified in VPN instance view applies to both the IPv4 VPN and the IPv6
VPN.
An export routing policy specified in IPv4 VPN view applies to only the IPv4 VPN.
An export routing policy specified in IPv4 VPN view takes precedence over that specified in VPN
instance view. If you specify an export routing policy in IPv4 VPN view and VPN instance view, the
IPv4 VPN uses the policy specified in IPv4 VPN view.
Examples
# Apply export routing policy poly-1 to VPN instance vpn1.
<Sysname> system-view
[Sysname] ip vpn-instance vpn1
[Sysname-vpn-instance-vpn1] export route-policy poly-1

ext-community-type

Syntax
ext-community-type { domain-id type-code1 | router-id type-code2 | route-type type-code3 }
undo ext-community-type { domain-id | router-id | route-type }
View
OSPF view
Default level
2: System level
Parameters
domain-id type-code1: Specifies the type code for the OSPF extended community attribute of
Domain ID. Valid values are 0x0005, 0x0105, 0x0205, and 0x8005.
router-id type-code2: Specifies the type code for the OSPF extended community attribute of Router
ID. Valid values are 0x0107 and 0x8001.
route-type type-code3: Specifies the type code for the OSPF extended community attribute of
Route Type. Valid values are 0x0306 and 0x8000.
Description
Use ext-community-type to configure the type code of an OSPF extended community attribute.
Use undo ext-community-type to restore the default.
By default, the type codes for the OSPF extended community attributes of Domain ID, Router ID, and
Route Type are 0x0005, 0x0107, and 0x0306 respectively.
Examples
# Configure the type codes of OSPF extended community attributes Domain ID, Router ID, and
Route Type as 0x8005, 0x8001, and 0x8000 respectively for OSPF process 100.
<Sysname> system-view
461