Filter-Policy Import (Ospfv3 View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

route and the destination keyword specifies the prefix of the route (the prefix must be valid;
otherwise, the configuration is ineffective).
Using the filter-policy export command filters only routes redistributed by the import-route
command. If the import-route command is not configured to redistribute routes from other protocols
and other OSPFv3 processes, use of the filter-policy export command does not take effect.
Examples
# Filter all redistributed routes using IPv6 ACL 2001.
<Sysname> system-view
[Sysname] acl ipv6 number 2001
[Sysname-acl6-basic-2001] rule permit source 2002:1:: 64
[Sysname-acl6-basic-2001] quit
[Sysname] ospfv3
[Sysname-ospfv3-1] filter-policy 2001 export
# Configure ACL6 3000 to permit only route 2001::1/128 to pass, and reference ACL6 3000 to filter
redistributed routes.
<Sysname> system-view
[Sysname] acl ipv6 number 3000
[Sysname-acl6-adv-3000] rule 10 permit ipv6 source 2001::1 128 destination
ffff:ffff:ffff:ffff:ffff:ffff:ffff:ffff 128
[Sysname-acl6-adv-3000] rule 100 deny ipv6
[Sysname-acl6-adv-3000] quit
[Sysname] ospfv3
[Sysname-ospfv3-1] filter-policy 3000 export

filter-policy import (OSPFv3 view)

Syntax
filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name } import
undo filter-policy import
View
OSPFv3 view
Default level
2: System level
Parameters
acl6-number: Specifies an ACL number, ranging from 2000 to 3999.
ipv6-prefix ipv6-prefix-name: Specifies the name of an IPv6 prefix list, a string of up to 19
characters.
Description
Use filter-policy import to configure OSPFv3 to filter routes computed from received LSAs.
Use undo filter-policy import to remove the configuration.
By default, OSPFv3 does not filter routes computed from received LSAs.
If you want to reference an advanced ACL (with a number from 3000 to 3999) in the command, the
ACL should be configured with the rule [ rule-id ] { deny | permit } ipv6 source sour sour-prefix
command to deny/permit a route with the specified destination, or with the rule [ rule-id ] { deny |
permit } ipv6 source sour sour-prefix destination dest dest-prefix command to deny/permit a route
with the specified destination and prefix. The source keyword specifies the destination address of a
311