Ospfv3 Area; Ospfv3 Bfd Enable - HP FlexNetwork 3600 v2 Series Command Reference Manual

An OSPFv3 process can run properly only when router ID is configured in OSPFv3 view. Otherwise,
you can find the process, but which cannot generate any LSA.
Related commands: router-id.
Examples
# Enable the OSPFv3 process with process ID as 120 and configure the Router ID as 1.1.1.1.
<Sysname> system-view
[Sysname] ospfv3 120
[Sysname-ospfv3-120] router-id 1.1.1.1

ospfv3 area

Syntax
ospfv3 process-id area area-id [ instance instance-id ]
undo ospfv3 process-id area area-id [ instance instance-id ]
View
Interface view
Default level
2: System level
Parameters
process-id: OSPFv3 process ID, in the range of 1 to 65535.
area-id: Area ID, a decimal integer (in the range of 0 to 4294967295) that is translated into IPv4
address format by the system or an IPv4 address.
instance-id: Instance ID of an interface, in the range of 0 to 255. The default is 0.
Description
Use ospfv3 area to enable an OSPFv3 process on the interface and specify the area for the
interface.
Use undo ospfv3 area to disable an OSPFv3 process.
OSPFv3 is not enabled on an interface by default.
Examples
# Enable OSPFv3 process 1 on an interface that belongs to instance 1 and specify area 1 for the
interface.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 1 area 1 instance 1

ospfv3 bfd enable

Syntax
ospfv3 bfd enable [ instance instance-id ]
undo ospfv3 bfd enable [ instance instance-id ]
View
Interface view
317