Ospfv3 Configuration Commands; Abr-Summary (Ospfv3 Area View); Area (Ospfv3 View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

OSPFv3 configuration commands

The term "router" in the chapter refers to both routers and Layer 3 switches.
HPE FlexNetwork 3600 v2 SI Switch Series does not support OSPFv3.

abr-summary (OSPFv3 area view)

Syntax
abr-summary ipv6-address prefix-length [ not-advertise ]
undo abr-summary ipv6-address prefix-length
View
OSPFv3 area view
Default level
2: System level
Parameters
ipv6-address: Destination IPv6 address of the summary route.
prefix-length: Prefix length of the destination IPv6 address, in the range of 0 to 128. This argument
specifies the number of consecutive 1s of the prefix, which defines the network ID.
not-advertise: Specifies not to advertise the summary IPv6 route.
Description
Use abr-summary to configure an IPv6 summary route on an area border router.
Use undo abr-summary to remove an IPv6 summary route. Then the summarized routes are
advertised.
By default, no route summarization is available on an ABR.
You can use this command only on an ABR to configure a summary route for the area. The ABR
advertises only the summary route to other areas. Multiple contiguous networks may be available in
an area, where you can summarize them with one route for advertisement.
Examples
# Summarize networks 2000:1:1:1::/64 and 2000:1:1:2::/64 in Area 1 with 2000:1:1::/48.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] area 1
[Sysname-ospfv3-1-area-0.0.0.1] abr-summary 2000:1:1:: 48

area (OSPFv3 view)

Syntax
area area-id
View
OSPFv3 view
Default level
2: System level
284