Isis Dis-Name - HP FlexNetwork 3600 v2 Series Command Reference Manual

Default level
2: System level
Parameters
value: Specifies an IS-IS cost for the interface. The cost range differs with cost styles.
•
For cost styles narrow, narrow-compatible and compatible, the cost ranges from 1 to 63.
•
For cost styles wide and wide-compatible, the cost ranges from 1 to 16777215.
level-1: Applies the cost to Level-1.
level-2: Applies the cost to Level-2.
Description
Use isis cost to set the IS-IS cost of an interface.
Use undo isis cost to restore the default.
No cost is configured by default.
If neither level-1 nor level-2 is included, the cost applies to both level-1 and level-2.
Hewlett Packard Enterprise recommends to configure a proper IS-IS cost for each interface to
guarantee correct route calculation.
Relate command: circuit-cost.
Examples
# Configure the Level-2 IS-IS cost as 5 for VLAN-interface10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis cost 5 level-2

isis dis-name

Syntax
isis dis-name symbolic-name
undo isis dis-name
View
Interface view
Default level
2: System level
Parameters
symbolic-name: Specifies a DIS name, a string of 1 to 64 characters.
Description
Use isis dis-name to configure a name for a DIS to represent the pseudo node on a broadcast
network.
Use undo isis dis-name to remove the configuration.
No name is configured for the DIS by default.
This command takes effect only on a router that must have dynamic system ID to host name
mapping enabled. This command is not supported on a Point-to-Point interface.
163