Reset Ip Ipv6-Prefix - HP FlexNetwork 3600 v2 Series Command Reference Manual

No IPv6 prefix list is configured by default.
An IPv6 prefix list may have multiple items, and each of them specifies a range of IPv6 prefixes. The
relation between items is logic OR. If a route passes an item of it, the route will pass the IPv6 prefix
list.
The IPv6 prefix range is determined by prefix-length and [ min-prefix-length, max-prefix-length ]. If
both mask-length and [ min-mask-length, max-mask-length ] are specified, then the IPv6 addresses
must satisfy both of them.
If ipv6-address prefix-length is specified as :: 0, only the default route matches.
To match all routes, configure :: 0 less-equal 128.
Examples
# Permit IPv6 addresses with a mask length between 32 bits and 64 bits.
<Sysname> system-view
[Sysname] ip ipv6-prefix abc permit :: 0 greater-equal 32 less-equal 64
# Deny IPv6 addresses with the prefix being 3FFE:D00::/32, and prefix length being greater than or
equal to 32 bits.
<Sysname> system-view
[Sysname] ip ipv6-prefix abc deny 3FFE:D00:: 32 less-equal 128

reset ip ipv6-prefix

Syntax
reset ip ipv6-prefix [ ipv6-prefix-name ]
View
User view
Default level
2: System level
Parameters
ipv6-prefix-name: IPv6 prefix list name, a string of 1 to 19 characters.
Description
Use reset ip ipv6-prefix to clear the statistics of the specified IPv6 prefix list. If no name is specified,
the statistics of all IPv6 prefix lists will be cleared.
Examples
# Clear the statistics of IPv6 prefix list abc.
<Sysname> reset ip ipv6-prefix abc
437