HP FlexNetwork 3600 v2 Series Command Reference Manual page 156

Description
Use display isis route to display IS-IS IPv4 routing information.
If no level is specified, both Level-1 and Level-2 routing information will be displayed.
Examples
# Display IS-IS IPv4 routing information.
<Sysname> display isis route 1
IPV4 Destination
--------------------------------------------------------------------------
1.1.0.0/16
1.2.0.0/16
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
IPV4 Destination
--------------------------------------------------------------------------
1.1.0.0/16
1.2.0.0/16
Flags: D-Direct, R-Added to RM, L-Advertised in LSPs, U-Up/Down Bit Set
Table 37 Command output
Field
Route information for ISIS(1)
ISIS(1) IPv4 Level-1 Forwarding Table
ISIS(1) IPv4 Level-2 Forwarding Table
IPv4 Destination
IntCost
ExtCost
ExitInterface
NextHop
Flags
Route information for ISIS(1)
-----------------------------
ISIS(1) IPv4 Level-1 Forwarding Table
-------------------------------------
IntCost ExtCost ExitInterface
20 NULL
10 NULL
ISIS(1) IPv4 Level-2 Forwarding Table
-------------------------------------
IntCost ExtCost ExitInterface
20 NULL
10 NULL
144
NextHop
Vlan11 1.2.1.1
Vlan11 Direct
NextHop
Vlan11 Direct
Description
Route information for IS-IS process 1.
IS-IS IPv4 routing information for Level-1.
IS-IS IPv4 routing information for Level-2.
IPv4 destination address.
Interior routing cost.
Exterior routing cost.
Exit interface.
Next hop.
Routing state flag:
•
D—Direct route.
•
R—The route has been added into the routing
table.
Flags
R/L/-
D/L/-
Flags
D/L/-