Ipv6 Bgp Configuration Commands; Aggregate (Ipv6 Address Family View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

IPv6 BGP configuration commands

The term "router" in this chapter refers to both routers and Layer 3 switches.
For more information about routing policy configuration commands in this document, see
policy configuration
HPE FlexNetwork 3600 v2 SI Switch Series does not support IPv6 BGP.

aggregate (IPv6 address family view)

Syntax
aggregate
detail-suppressed | origin-policy route-policy-name | suppress-policy route-policy-name ] *
undo aggregate ipv6-address prefix-length
View
IPv6 address family view
Default level
2 System level
Parameters
ipv6-address: Summary address.
prefix-length: Length of summary route mask, in the range of 0 to 128.
as-set: Creates a summary with AS set.
attribute-policy route-policy-name: Sets the attributes of the summary route according to the
routing policy. The routing policy name is a string of 1 to 63 characters.
detail-suppressed: Only advertises the summary route.
suppress-policy route-policy-name: Suppresses specific routes defined in the routing policy. The
routing policy name is a string of 1 to 63 characters.
origin-policy route-policy-name: References the routing policy to specify routes for summarization.
The routing policy name is a string of 1 to 63 characters.
Table 80 Functions of the keywords
Keywords
as-set
detail-suppressed
suppress-policy
origin-policy
attribute-policy
commands."
ipv6-address prefix-length
Function
Used to create a summary route, whose AS path contains the AS path
information of summarized routes. Use this keyword carefully when many
AS paths need to be summarized, because the frequent changes of these
specific routes may lead to route oscillation.
This keyword does not suppress the summary route, but it suppresses the
advertisement of all the more specific routes. To summarize only some
specific routes, use the peer filter-policy command.
Used to create a summary route and suppress the advertisement of some
summarized routes. If you want to suppress some routes selectively and
leave other routes still advertised, use the if-match clause of the
route-policy command.
Selects only routes satisfying the routing policy for route summarization.
Sets attributes except the AS_PATH attribute for the summary route. The
[ |
as-set attribute-policy
343
"Routing
|
route-policy-name