Ripng; Ripng Default-Route - HP FlexNetwork 3600 v2 Series Command Reference Manual

Examples
# Clear the statistics of RIPng process 100.
<Sysname> reset ripng 100 statistics

ripng

Syntax
ripng [ process-id ] [ vpn-instance vpn-instance-name ]
undo ripng [ process-id ] [ vpn-instance vpn-instance-name ]
View
System view
Default level
2: System level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535. The default value is 1.
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN. vpn-instance-name is a
case-sensitive string of 1 to 31 characters.
Description
Use ripng to create a RIPng process and enter RIPng view.
Use undo ripng to disable a RIPng process.
By default, no RIPng process is enabled.
•
If no VPN is specified, the RIPng process is enabled for the public network.
•
The specified VPN instance must have been created with the ip vpn-instance command.
•
Before configuring global RIPng parameters, you must create a RIPng process. This
requirement does not apply to interface RIPng parameter configuration.
•
After you disable a RIPng process, the RIPng parameters on interface running the process also
become ineffective.
Examples
# Create RIPng process 100 and enter its view.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100]
# Disable RIPng process 100.
[Sysname] undo ripng 100
# Create RIPng process 101 and bind it to VPN instance vpn101.
<Sysname> system-view
[Sysname] ripng 101 vpn-instance vpn101

ripng default-route

Syntax
ripng default-route { only | originate } [ cost cost ]
undo ripng default-route
277