Ip Policy-Based-Route - HP FlexNetwork 3600 v2 Series Command Reference Manual

View
System view
Default level
2: System level
Parameters
policy-name: Policy name, a string of 1 to 19 characters.
Description
Use ip local policy-based-route to configure local PBR based on a specified policy.
Use undo ip local policy-based-route to remove the configuration.
No policy is referenced for local PBR by default.
Only one policy can be referenced for local PBR.
Local PBR is used to route packets generated locally. Unless otherwise required, Hewlett Packard
Enterprise does not recommend configuring local PBR.
Examples
# Configure local PBR based on policy aaa.
<Sysname> system-view
[Sysname] ip local policy-based-route aaa

ip policy-based-route

Syntax
ip policy-based-route policy-name
undo ip policy-based-route policy-name
View
Interface view
Default level
2: System level
Parameters
policy-name: Policy name, a string of 1 to 19 characters.
Description
Use ip policy-based-route to configure PBR on the interface.
Use undo ip policy-based-route to remove the configuration.
No policy is referenced for interface PBR by default.
Note that:
•
Only one policy can be referenced by an interface for PBR.
•
The referenced policy applies to all packets arriving on the interface.
Examples
# Configure PBR based on policy aaa on Vlan-interface 11.
<Sysname> system-view
[Sysname] interface Vlan-interface 11
[Sysname-Vlan-interface11] ip policy-based-route aaa
444