Default Cost; Default-Cost (Ospfv3 Area View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

default cost

Syntax
default cost value
undo default cost
View
OSPFv3 view
Default level
2: System level
Parameters
value: Specifies a default cost for redistributed routes, in the range of 1 to 16777214.
Description
Use default cost to configure a default cost for redistributed routes.
Use undo default cost to restore the default.
By default, the default cost is 1.
You need to configure the default cost value for redistributed routes to advertise them throughout the
whole AS.
If multiple OSPFv3 processes are available, use of this command takes effect for the current process
only.
Examples
# Specify the default cost for redistributed routes as 10.
<Sysname> system-view
[Sysname] ospfv3 1
[Sysname-ospfv3-1] default cost 10

default-cost (OSPFv3 area view)

Syntax
default-cost value
undo default-cost
View
OSPFv3 area view
Default level
2: System level
Parameters
value: Specifies a cost for the default route advertised to the stub area, in the range of 0 to 65535.
The default is 1.
Description
Use default-cost to specify the cost of the default route to be advertised to the stub area.
Use undo default-cost to restore the default value.
Use of this command is only available on the ABR that is connected to a stub area.
286