Ospfv3 Timer Retransmit; Ospfv3 Timer Poll - HP FlexNetwork 3600 v2 Series Command Reference Manual

Description
Use ospfv3 timer hello to configure the hello interval for an interface that belongs to an instance.
Use undo ospfv3 timer hello to restore the default .
By default, the hello interval is 10 seconds for P2P and Broadcast interfaces, and is not supported on
the P2MP or NBMA interfaces.
Related commands: ospfv3 timer dead.
Examples
# Configure the hello interval as 20 seconds for an interface in instance 1.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer hello 20 instance 1

ospfv3 timer retransmit

Syntax
ospfv3 timer retransmit interval [ instance instance-id ]
undo ospfv3 timer retransmit [ interval ] [ instance instance-id ]
View
Interface view
Default level
2: System level
Parameters
interval: LSA retransmission interval in seconds, ranging from 1 to 65535.
instance-id: Instance ID of an interface, in the range of 0 to 255, which defaults to 0.
Description
Use ospfv3 timer retransmit to configure the LSA retransmission interval for an interface in an
instance.
Use undo ospfv3 timer retransmit to restore the default.
The interval defaults to 5 seconds.
After sending a LSA to its neighbor, the device waits for an acknowledgement. If receiving no
acknowledgement after the LSA retransmission interval elapses, it will retransmit the LSA.
The LSA retransmission interval should not be too small for avoidance of unnecessary
retransmissions.
Examples
# Configure the LSA retransmission interval on an interface in instance 1 as 12 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] ospfv3 timer retransmit 12 instance 1

ospfv3 timer poll

Syntax
ospfv3 timer poll seconds [ instance instance-id ]
323