Ipv6 Filter-Policy Export - HP FlexNetwork 3600 v2 Series Command Reference Manual

Use undo ipv6 enable to disable IPv6.
IPv6 is disabled by default.
Examples
# Create IS-IS routing process 1, and enable IPv6 for the process.
<Sysname> system-view
[Sysname] ipv6
[Sysname] isis 1
[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00
[Sysname-isis-1] ipv6 enable

ipv6 filter-policy export

Syntax
ipv6 filter-policy { acl6-number | ipv6-prefix ipv6-prefix-name | route-policy route-policy-name }
export [ protocol [ process-id ] ]
undo ipv6 filter-policy export [ protocol [ process-id ] ]
View
IS-IS view
Default level
2: System level
Parameters
acl6-number: Number of a basic or advanced IPv6 ACL used to filter redistributed routes before
advertisement, ranging from 2000 to 3999. See ACL and QoS Configuration Guide for ACL
information.
ipv6-prefix-name: Name of an IPv6 prefix list used to filter the redistributed routes before
advertisement, a case-sensitive string of 1 to 19 characters. See Layer 3—IP Routing Configuration
Guide for IPv6 prefix list information.
route-policy-name: Name of a routing policy used to filter the redistributed routes before
advertisement, a case-sensitive string of 1 to 63 characters. See Layer 3—IP Routing Configuration
Guide for routing policy information.
protocol: Routing protocol from which the redistributed routes are to be filtered. The routing protocol
can be bgp4+, direct, isisv6, ospfv3, ripng, or static. If no protocol is specified, routes
redistributed from all protocols are filtered.
process-id: Process ID of the routing protocol, ranging from 1 to 65535. This argument is available
when the protocol is isisv6, ospfv3, or ripng.
Description
Use ipv6 filter-policy export to configure IPv6 IS-IS to filter redistributed routes before
advertisement.
Use undo ipv6 filter-policy export to disable the filtering.
The filtering is disabled by default.
In some cases, only routes satisfying certain conditions will be advertised. You can configure the
filtering conditions using the ipv6 filter-policy command.
You can use the ipv6 filter-policy export command, which filters redistributed routes only when
they are advertised to other routers, in combination with the ipv6 import-route command.
334