Apply Cost - HP FlexNetwork 3600 v2 Series Command Reference Manual

no-export: Sets the NO_EXPORT community attribute for BGP routes. Routes with this attribute
cannot be advertised out of the autonomous system or confederation, but can be advertised to other
sub ASs in the confederation.
no-export-subconfed: Sets the NO_EXPORT_SUBCONFED community attribute for BGP routes.
Routes with this attribute cannot be advertised out of the sub autonomous system.
additive: Adds the specified COMMUNITY attribute to the original COMMUNITY attribute of BGP
routes.
Description
Use apply community to set the specified COMMUNITY attribute for BGP routes.
Use undo apply community to remove the apply clause.
No COMMUNITY attribute is set for BGP routes by default.
Related commands: ip community-list and if-match community.
Examples
# Configure node 16 in permit mode of routing policy setcommunity to set the NO_EXPORT
community attribute for BGP routes matching AS path list 8.
<Sysname> system-view
[Sysname] route-policy setcommunity permit node 16
[Sysname-route-policy] if-match as-path 8
[Sysname-route-policy] apply community no-export

apply cost

Syntax
apply cost [ + | - ] value
undo apply cost
View
Routing policy view
Default level
2: System level
Parameters
+: Increases a cost value.
-: Decreases a cost value.
value: Cost in the range of 0 to 4294967295.
Description
Use apply cost to set a cost for routing information.
Use undo apply cost to remove the clause configuration.
No cost is set for routing information by default.
Examples
# Configure node 10 in permit mode of routing policy policy1: set a cost of 120 for routing
information whose outbound interface is Vlan-interface 20.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match interface Vlan-interface 20
411