Isis Timer Retransmit - HP FlexNetwork 3600 v2 Series Command Reference Manual

Parameters
time: Specifies the minimum interval in milliseconds for sending link-state packets, ranging from 1 to
1000.
count: Specifies the maximum number of link-state packets to be sent at one time, in the range of 1
to 1000. The default is 5.
Description
Use isis timer lsp to configure the minimum interval for sending LSPs on the interface and specify
the maximum LSPs that can be sent per time.
Use undo isis timer lsp to restore the default of 33 ms.
Related commands: isis timer retransmit.
NOTE:
This command is not available in loopback interface view.
Examples
# Configure the interval as 500 milliseconds for sending LSPs on interface VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] isis timer lsp 500

isis timer retransmit

Syntax
isis timer retransmit seconds
undo isis timer retransmit
View
Interface view
Default level
2: System level
Parameters
seconds: Specifies the interval in seconds for retransmitting LSP packets, ranging from 1 to 300.
Description
Use isis timer retransmit to configure the interval for retransmitting LSP packets over a
point-to-point link.
Use undo isis timer retransmit to restore the default.
By default, the retransmission interval is 5 seconds.
A P2P link requires a response to a sent LSP. If no response is received within the retransmission
interval, the LSP is retransmitted.
You need not use this command over a broadcast link where CSNPs are broadcast periodically.
Configure a proper retransmission interval to avoid unnecessary retransmissions.
Perform this configuration only when the link layer protocol is PPP.
NOTE:
This command is not available in loopback interface view.
170