Log-Peer-Change - HP FlexNetwork 3600 v2 Series Command Reference Manual

allow-ibgp: Allows redistributing IBGP routes. This keyword takes effect only the protocol is bgp4+.
cost value: Specifies a cost for redistributed routes, ranging from 1 to 16777214. The default is 1.
route-policy route-policy-name: Redistributes only the routes that match the specified routing policy.
route-policy-name is a case-sensitive string of 1 to 63 characters.
type type: Specifies the type for redistributed routes, 1 or 2. It defaults to 2.
NOTE:
Using the import-route bgp4+ command redistributes only eBGP routes, and using the
import-route bgp4+ allow-ibgp command redistributes both eBGP and IBGP routes.
Description
Use import-route to redistribute routes.
Use undo import-route to disable routes redistribution.
IPv6 OSPFv3 does not redistribute routes from other protocols by default.
Examples
# Configure to redistribute routes from RIPng and specify the type as type 2 and cost as 50.
<Sysname> system-view
[Sysname] ospfv3
[Sysname-ospfv3-1] import-route ripng 10 type 2 cost 50
# Configure OSPFv3 process 100 to redistribute the routes found by OSPFv3 process 160.
<Sysname> system-view
[Sysname] ospfv3 100
[Sysname-ospfv3-100] import-route ospfv3 160

log-peer-change

Syntax
log-peer-change
undo log-peer-change
View
OSPFv3 view
Default level
2: System level
Parameters
None
Description
Use log-peer-change to enable the logging on neighbor state changes.
Use undo log-peer-change to disable the logging.
With this feature enabled, information about neighbor state changes of the current OSPFv3 process
will display on the configuration terminal.
Examples
# Disable the logging on neighbor state changes of OSPFv3 process 100.
<Sysname> system-view
315