Policy-Based Routing Configuration Commands; Apply Ip-Address Default Next-Hop; Apply Ip-Address Next-Hop - HP FlexNetwork 3600 v2 Series Command Reference Manual

Policy-based routing configuration
commands
This chapter describes only PBR commands (using a PBR policy).
For description of PBR commands (using a QoS policy), such as the traffic classification, traffic
behavior, and QoS policy configuration commands, see ACL and QoS Command Reference.

apply ip-address default next-hop

Syntax
apply ip-address default next-hop ip-address [ track track-entry-number ] [ ip-address [ track
track-entry-number ] ]
undo apply ip-address default next-hop [ ip-address [ ip-address ] ]
View
PBR policy node view
Default level
2: System level
Parameters
ip-address: IP address of the default next hop.
track track-entry-number: Specifies a track entry. The track-entry-number argument is in the range
of 1 to 1024.
Description
Use apply ip-address default next-hop to set the default next hop(s).
Use undo apply ip-address default next-hop to remove the configuration.
You can specify up to two default next hops in one command line.
Using the undo apply ip-address default next-hop command with a next hop specified removes
the default next hop. Using this command without any next hop specified removes all default next
hops.
The default next hop must belong to the public network instead of a VPN.
Examples
# Set the default next hop to 1.1.1.1.
<Sysname> system-view
[Sysname] policy-based-route aa permit node 11
[Sysname-pbr-aa-11] apply ip-address default next-hop 1.1.1.1 track 1

apply ip-address next-hop

Syntax
apply ip-address next-hop ip-address [ direct ] [ track track-entry-number ] [ ip-address [ direct ]
[ track track-entry-number ] ]
undo apply ip-address next-hop [ ip-address [ ip-address ] ]
438