Graceful-Restart (Bgp View) - HP FlexNetwork 3600 v2 Series Command Reference Manual

Use undo filter-policy import to disable the filtering.
By default, incoming routing information is not filtered.
If you want to reference an advanced ACL (with a number from 3000 to 3999) in the command, the
ACL should be configured with the rule [ rule-id ] { deny | permit } ip source sour-addr sour-wildcard
command to deny/permit a route with the specified destination, or with the rule [ rule-id ] { deny |
permit } ip source sour-addr sour-wildcard destination dest-addr dest-wildcard command to
deny/permit a route with the specified destination and mask. The source keyword specifies the
destination address of a route and the destination keyword specifies the subnet mask of the route
(the subnet mask must be valid; otherwise, the configuration is ineffective).
Examples
# In BGP view, reference ACL 2000 to filter incoming routing information.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] filter-policy 2000 import
# In BGP-VPN instance view, reference ACL 2000 to filter incoming routing information. (The VPN
has been created.)
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] ipv4-family vpn-instance vpn1
[Sysname-bgp-ipv4-vpn1] filter-policy 2000 import
# Configure ACL 3000 to permit only route 113.0.0.0/16 to pass, and reference ACL 3000 to filter
incoming route information.
<Sysname> system-view
[Sysname] acl number 3000
[Sysname-acl-adv-3000] rule 10 permit ip source 113.0.0.0 0 destination 255.255.0.0 0
[Sysname-acl-adv-3000] rule 100 deny ip
[Sysname-acl-adv-3000] quit
[Sysname] bgp 100
[Sysname-bgp] filter-policy 3000 import

graceful-restart (BGP view)

Syntax
graceful-restart
undo graceful-restart
View
BGP view
Default level
2: System level
Parameters
None
Description
Use graceful-restart to enable BGP Graceful Restart capability.
Use undo graceful-restart to disable BGP Graceful Restart capability.
By default, BGP Graceful Restart capability is disabled.
221