Cost-Style - HP FlexNetwork 3600 v2 Series Command Reference Manual

Use undo circuit-cost to restore the default.
By default, no global link cost is configured.
If no level is specified, the specified cost applies to both Level-1 and Level-2.
Related commands: isis cost and cost-style.
Examples
# Set the global Level-1 link cost of IS-IS process 1 to 11.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] circuit-cost 11 level-1

cost-style

Syntax
cost-style { narrow | wide | wide-compatible | { compatible | narrow-compatible }
[ relax-spf-limit ] }
undo cost-style
View
IS-IS view
Default level
2: System level
Parameters
narrow: Receives and sends only narrow cost style packets (The narrow cost ranges from 0 to 63).
wide: Receives and sends only wide cost style packets (The wide cost ranges from 0 to 16777215).
compatible: Receives and sends both wide and narrow cost style packets.
narrow-compatible: Receives both narrow and wide cost style packets, but sends only narrow cost
style packets.
wide-compatible: Receives both narrow and wide cost style packets, but sends only wide cost style
packets.
relax-spf-limit: Allows receiving routes with a cost greater than 1023. If this keyword is not specified,
any route with a cost bigger than 1023 will be discarded. This keyword is only available when
compatible or narrow-compatible is included.
Description
Use cost-style to set a cost style.
Use undo cost-style to restore the default.
Only narrow cost style packets can be received and sent by default.
Related commands: isis cost and circuit-cost.
Examples
# Configure the router to send only narrow cost style packets, but receive both narrow and wide cost
style packets.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] cost-style narrow-compatible
129