Displaying And Maintaining The Routing Policy; Routing Policy Configuration Examples; Routing Policy Configuration Example For Ipv4 Route Redistribution - HP FlexFabric 12900E Series Configuration Manual

Step
3. Specify the next node to be
matched.

Displaying and maintaining the routing policy

Execute display commands in any view and reset commands in user view.
Task
Display BGP AS path list information.
Display
information.
Display BGP extended community list
information.
Display IPv4 prefix list statistics.
Display IPv6 prefix list statistics.
Display routing policy information.
Clear IPv4 prefix list statistics.
Clear IPv6 prefix list statistics.

Routing policy configuration examples

Routing policy configuration example for IPv4 route
redistribution
Network requirements
As shown in
with Switch C by using IS-IS.
On Switch B, enable route redistribution from IS-IS to OSPF. Use a routing policy to set the cost of
route 172.17.1.0/24 to 100 and the tag of route 172.17.2.0/24 to 20.
BGP community
Figure 112, Switch B exchanges routing information with Switch A by using OSPF and
Command
continue [ node-number ]
Command
display ip as-path [ as-path-number ]
display ip community-list [ basic-community-list-number |
list
adv-community-list-number | name comm-list-name ]
display ip extcommunity-list [ ext-comm-list-number ]
display ip prefix-list [ name prefix-list-name ]
display ipv6 prefix-list [ name prefix-list-name ]
display route-policy [ name route-policy-name ]
reset ip prefix-list [ prefix-list-name ]
reset ipv6 prefix-list [ prefix-list-name ]
482
Remarks
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.