Configuring Abr Type-3 Lsa Filtering; Configuring An Ospf Cost For An Interface - HP 3600 v2 series Configuration Manual

Configuring ABR Type-3 LSA filtering

You can configure an ABR to filter Type-3 LSAs advertised to an area.
Follow these steps to configure Type-3 LSA filtering on an ABR:
To do...
Enter system view
Enter OSPF view
Enter area view
Configure ABR Type-3 LSA filtering

Configuring an OSPF cost for an interface

You can configure an OSPF cost for an interface by using either of the following methods:
• Configure the cost value in interface view
Configure a bandwidth reference value for the interface. OSPF computes the cost with this formula:
•
Interface OSPF cost = Bandwidth reference value (100 Mbps) ÷ Interface bandwidth (Mbps). If the
calculated cost is greater than 65535, the value of 65535 is used. If the calculated cost is less than
1, the value of 1 is used.
If the cost value is not configured for an interface, OSPF computes the interface cost automatically.
Follow these steps to configure an OSPF cost for an interface:
To do...
Enter system view
Enter interface view
Configure an OSPF cost for
the interface
Follow these steps to configure a bandwidth reference value:
To do...
Enter system view
Enter OSPF view
Configure a bandwidth
reference value
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
area area-id
filter { acl-number | ip-prefix
ip-prefix-name } { import | export }
Use the command...
system-view
interface interface-type
interface-number
ospf cost value
Use the command...
system-view
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
bandwidth-reference value
82
Remarks
—
—
—
Required
Not configured by
default.
Remarks
—
—
Optional
The default cost depends on the interface
type: 1 for a VLAN interface; 0 for a
loopback interface; computed according
to the bandwidth for other interfaces.
Remarks
—
—
Optional
The value defaults to 100
Mbps.