Table of Contents
Advertisement
B
Changing Fonts/Overlays
B.t
Command Diagram
LPRINT CHR$ (27);" [n 1 ;n2;n 3
s"
. - - - -_ _ _ _ ..... 1
I
I
I
FONT NUMBER
I
B.2
Using the Command
o
=
DELETE FONT OR
OVERLAY
1
=
SELECT FONT OR
OVERLAY (DEFAUL1)
2
=
DELETE ALL FONTS
AND OVERLAYS
3
=
DELETE ONLY FONTS
IN SELECTED ORI-
ENTATION
This software command allows you to change fonts, select
a pre-defined overlay from the printer's memory, to delete
a particular downloaded font or overlay from the printer's
memory, or to delete only downloaded fonts in a particular
orientation.
• Omitting
nl
causes the power-up default font in the
current page orientation to be selected.
&I
If
nl
is omitted and "overlay" is selected
in
n2,
the
printer ignores the entire command.
• Overlays can only be defined through the ANSI com-
mand mode. See the ANSI X3.64 Programming M an-
ual.
• Only downloaded fonts and overlays may be deleted.
• Any font selected using this software command re-
mains in effect until you select another font or until
you do a printer reset. This command will override
Software Commands
4-3
Advertisement
Table of Contents
