Table of Contents
Advertisement
I
<ESC>&lnlO
I
Orientation
This command prints the current page (if any), then selects
the orientation for printing on subsequent pages, depend-
ing on the value of parameter
nl:
<ESC>&IOO
Portrait
<ESC>&110
Landscape
This command defaults the following parameters: top
margin, text length, left and right margins, horizontal spac-
ing and vertical spacing.
The
Orientation
command has important implications in
font definition, because the current font orientation must
match the page orientation.
Your QMS printer rotates landscape printing in the op-
posite direction to HP LaserJet printers. That is, QMS
landscape printing is rotated 180 degrees with respect to
HP LaserJet landscape printing. Note, however, that fonts
are rotated 180 degrees in printer software, so this change
is essentially transparent.
3
I
<ESC>&lnlP
I
Page Length
This command prints the current page
(if
any), then speci-
fies the length of each page from the current paper source.
Parameter
nl
is the page length in lines, based on the cur-
rent line spacing. For example, the command
<ESC>&I84P
would specify legal-size paper at a current line spacing of
6 lines/inch (14 inches times 6 lines/inch).
The page length is always specified as the physical length
of the sheet, regardless of whether you are using portrait or
landscape orientation. Changes to page orientation should
be made
after
specifying the page length.
3Envelopes must be loaded differently in the manual feed tray (see "Paper
Handling Commands· later in this section).
H-14
HP Emulation Mode
Advertisement
Table of Contents
