Table of Contents
Advertisement
I
<ESC>31
GRAPHICS
"ON" -
1/60"
Graphics Mode commands affect print position movement
or spacing. When this Graphics command is used, the
Space and Backspace commands move the print position
1/60 inch. Line Feed and Negative Line Feed commands
cause the print position to move 1/48 inch and the Au-
tomatic Line Feed command is ignored altogether. Any
Character Printing command will cause no change in print
position after the character is printed.
The Graphics Mode may be terminated by any of the fol-
lowing:
Graphics Mode "OFF"
Carriage Return
Either ResetlRestore Command
Power the printer OFF/ON
I
<ESC>G
I
GRAPHICS
"ON" -
11120"
Like the Graphics command above, this command affects
the movement and spacing of the print position. The only
difference between the two commands is that this com-
mand causes the Space and Backspace commands to move
the print position 1/120 inch. All other conditions are the
same as indicated above.
I
<ESC>41
GRAPHICS
"OFF"
This command may be used
to
terminate both of the above
Graphics Mode "ON" commands.
Qume Emulation Mode
G-31
Advertisement
Table of Contents
