QMS SmartWriter 80+ User Manual page 293

fect until changed by one of the other two High-Order Bit
Control commands or until a "warm restart" or complete
power-off/power-on is performed. The <ESC>= command
will not affect interpretation of the ESCape codes by the
printer.
I
<ESC>#
I
SET HIGH-ORDER CONTROL TO "OFF"
This command sets the High-Order Control to "OFF" so
that the eighth or Most Significant Bit (MSB) can be in-
terpreted "as is" (either off or on). This
~ommand
will re-
main in effect until changed by one of the other two High-
Order Bit Control commands or until a "warm restart" or
complete power-off/power-on is performed.
I
<ESC>Rn
I
SELECT INTERNATIONAL
CHARACTER SET
The printer allows access to special characters for nine
different countries through this command. The values for
'n' in the command are:
<NUL> USA <ETX> England
<SOH> France <EOT> Denmark
<STX> Germany <ENQ> Sweden
<ACK> Italy
<BEL> Spain
<BS> Japan
Refer to your host computer or word processor documen-
tation for instructions on embedding the ASCII control
characters in the place of On' in the above command
The International Character Set may also be accessed
through Group E Options 3 through 5. If you are us-
ing a word processor, type the visible equivalents of the
decimal values at the top of each column. The character
that prints will be the character associated with that value
in the selected character set. The international character
sets (see Table
4)
will also print in italics if Italic Mode
is selected.
Examples:
<ESC>R<STX> Selects German character set
<ESC>R<BEL> Selects Spanish character set
Appendix E
E-31