Table of Contents
Advertisement
I
<ESC>C<n>
I
SET FORMS LENGTH IN LINES
This command is used to set Fonns Length in terms of
the desired number of lines per page. The valid range
for <n> in the command is 0-255. The printer converts
the number of lines specified by <n> to inches using the
current line spacing. The printer saves the form length in
inches and does not change the fonn length if line spacing
is changed.
Examples:
<ESC>CB
Set Fonns Length to 66 lines
<ESC>C<CAN> Set Forms Length to 24 lines
C.6
Line Spacing Commands
These commands set line spacing.
• SET LINE SPACING TO 1/8 INCH establishes a
line spacing value of 8 lines per inch.
• SET LINE SPACING TO 7/72 INCH establishes a
line spacing value 7 lines per inch.
• SET LINE SPACING TO n/72 INCH allows you to
establish your own line spacing value in 1/72" incre-
ments.
• SET GRAPHICS LINE SPACING (n/216 INCH) al-
lows you to establish a line spacing value in 1/216"
increments.
I
<ESC>O
I
SET LINE SPACING TO 1/8 INCH
/'
This command sets the Line Spacing to 8 lines per inch.
\
Whenever a <LF>command is received, the paper will
move
1/8
inch.
F-18
Proprinter Emulation Mode
Advertisement
Table of Contents
