Table of Contents
Advertisement
• GRAPHICS OFF causes the printer to resume normal
printing.
• FORWARD PRINTING causes printing from left to
right.
• REVERSE PRINTING causes printing from right to
left.
• RETURN HMI TO KEYPAD OPTION VALUE re-
sets HMI to the value selected in the Group D Op-
tions.
• PRINT SPECIAL CHARACTER allows access to
the Hex 9E and Hex 9F characters (cent sign and
apostrophe ).
I
<ESC><CR>P
I
TOTAL RESET TO POWER-UP
DEFAULTS
U sing this command will cause the printer to be returned
to ALL the default conditions. It has the same results as
turning the printer "OFF" and, then, back "ON" except
that no data will be lost by using the Reset command.
The default conditions that are reset are as follows:
Primary Character Set <SI>.
Margins set to their default value.
Bold and Shadow print disabled.
Character Spacing set to keypad selection.
Offset Selection is cleared.
Auto Underscore is turned "OFF."
Forward Print Mode enabled.
Line Spacing set to keypad selection.
All Horizontal and Vertical Tabs cleared.
Print Position set to Top and Left Margins of next page.
Graphics Mode disabled.
Print Suppression cleared.
D-20
Diablo Emulation Mode
Advertisement
Table of Contents
