Table of Contents
Advertisement
first value. A Reset/Restore command will return the Left
Margin setting to column O.
The Left Margin may also be set by using the keypad to
configure Group 4 Options 1, 2, 3, and 4.
L
<ESC>O
I
SET RIGHT MARGIN
The Right Margin setting is measured from the left edge of
the page. Issue the required number of <SP> commands to
reach the desired Right Margin and issue the <ESC>O com-
mand. The physical distance represented by each <SP>
command depends on the Horizontal Motion Index or
the character spacing selected in Group Q Options
1
and
2.
For example, if the Horizontal Motion Index
is set for 10 characters per inch and the page orientation
is portrait, issuing 80 <SP> commands and the <ESC>O
command would set a Right Margin of one-half inch.
The default Right Margin is the right-most print column
of the page depending on the current paper size.
The Right Margin may also be set by using the keypad to
configure Group 4 Options 5, 6, 7, and 8.
I
<ESC>
Ln
ln21 VERTICAL MOTION INDEX
This command (also known as VMI) sets the number of
lines per inch (lpi) which the printer will print. Lines are
spaced in increments of 1/48 inch. The valid range of val-
ues for the VMI is 1-159 (48 Ipi - .3 Ipi). In the command
above, "nl" represents the "tens" digit of the VMI values
below 100. For VMI values above 100, n1 will be a letter
from the table below. For all VMI values, n2 is always
the units digit (0-9).
Qume Emulation Mode
0-11
Advertisement
Table of Contents
