Table of Contents
Advertisement
ECS 7-Bit ASCII Mode
For those systems which use a 7-Bit ASCII Mode of oper-
ation, the Primary Character Set codes 00-7F are in effect
at power-up. To access the Secondary Character Set, send
the Shift-Out
<SO>
command to the printer. Once this
<SO>
command has been sent, the only commands which
will be recognized are the Shift-In <SI> and Space <SP>
commands. All other control codes are used to address
Secondary Characters. The <SI> character will return you
to use of the Primary Character Set.
ECS 8·Bit ASCII Mode
For those systems which use an 8-Bit ASCII Mode of op-
eration, the Primary Character Set codes 00-7F are in ef-
fect at power-up. To access the Secondary Character Set,
send the Shift-Out
<SO>
command to the printer. Once
this <SO> command has been sent, all codes 00-9F are
accessible. The Shift-In <S1> character will return you
to use of only the Primary Character Set. The software
power-up Reset command, <ESC><CR> P, will also return
you to just the Primary Character Set.
0-30
Diablo Emulation Mode
Advertisement
Table of Contents
