Table of Contents
Advertisement
I
<ESC>91 SET LEFT MARGIN
The default left margin is the left edge of the page. The
left margin setting is measured from the left edge of the
page and may not be set beyond the Right Margin.
Issue <SP> commands until you reach the desired
Left'~
Margin.
The actual distance represented
by
each
<SP>
command is determined
by
the Horizontal Motion
dex or
by
the "pitch" set in Group D Options 1
2. When you have reached the desired Left Margin, issue
the <ESC>9 command.
For example, the following sequence of commands would
establish a Left Margin three "print positions" from the
left edge of the page:
<SP><SP><SP><ESC>9
Once a left margin is set it remains in effect until you issue
a Diablo Total Reset command «ESC><CR>P), establish
a new left margin, or leave Diablo Emulation Mode and
perlorrn a reset of the printer.
Setting a new left margin to the right of the existing left
margin requires issuing the additional number of <SP>
commands to bring the cursor to the desired position.
Once there, issue the <ESC>9 command to establish the
new margin. For example, if the existing left margin is
10 spaces from the left edge of the paper and you wish to
establish a new left margin 15 spaces from the left edge,
position the cursor at the existing left margin and issue 5
space commands followed by the <ESC>9 command.
If you wish to set a new left margin to the
left of the
existing left margin, issue the correct number of <BS>
(Backspace) commands to bring the cursor to the desired
position followed by the <ESC>9 command. For example,
if the existing left margin is 10 spaces from the left edge
of the paper and you wish to establish a new left margin
5 spaces from the left edge of the paper, position the
cursor at the existing left margin and issue 5 backspace
commands followed by the <ESC>9 command.
D-12
Diablo Emulation Mode
Advertisement
Table of Contents
