Table of Contents
Advertisement
I
<ESC>&pnl Xn21
Transparent Print Data
This command causes the printer to ignore any commands
in the following n1bytes of data n2'
This command is helpful when sending a screen dump
to the printer which contains ASCII control codes. For
example, MS-DOS systems use control codes to represent
certain line drawing symbols.
I
<ESC>&knl G
I
Line Termination
This command determines how the printer responds to
<CR>, <LF> and <FF> commands. The table below lists
the valid values of parameter nland the effect on the three
printer control codes.
o
<CR>
<LF>
<FF>
1
<CR> <LF>
<LF>
<FF>
2
<CR>
<CR> <LF>
<CR><FF>
3
<CR> <LF>
<CR> <LF>
<CR><FF>
I
<ESC>&snl C
I
End-of-Line Wrap
This command enables or disables line wrap, depending
on the value of parameter nl:
Command
Action
<ESC>&sOC
Enable line wrap
<ESC>&slC
Disable line wrap
With line wrap enabled, a carriage return/line feed se-
quence is automatically executed whenever the character
about to be printed will fall to the right of the current
right-hand margin.
H-62
HP Emulation Mode
Advertisement
Table of Contents
