QMS SmartWriter 80+ User Manual page 340

Special Printer Features
<ESC><SUB>I Total ResetlRestore
<ESC><CR>P Alternate Total ResetlRestore
<ESC>S No Print "ON"
<ESC> T No Print "OFF"
<ESC>3 Graphics "ON" 1/60"
<ESC>G Graphics "ON" 1/120"
<ESC>4 Graphics "OFF'
<ESC>/ Print Character located at Wheel
Position 002
<ESC><SP> Print Character located at Wheel
Position 004
When using the supported commands, refer to the ASCII
conversion table in Appendix B at the back of this manual
to determine the value for "n" in those commands which
require variable parameters. Use the appropriate conver-
sion value (ASCII, Hex, Decimal, etc.) required by your
computer system and the programming language being
used.
B
Unsupported Qume
mands
Com-
The following commands are not supported by the printer.
If these commands are sent, they will be absorbed by the
printer and will not affect printing.
Q ume Printer Features
<ESC>F Set Form Length
<ESC>O Right Margin Control "ON"
<ESC> Y Right Margin Control "OFF"
<ESC» Auto Bidirectional Printing "ON"
<ESC>< Auto Bidirectional Printing "OFF"
0-4
Qume Emulation Mode
.1
:
."