Table of Contents
Advertisement
I
<ESC>E
I
UNDERSCORE "ON"
This command is used to indicate where you want Un-
derscoring to begin. An <ESC>R indicates where the Un-
derscoring should end. Underscore will continue on sub-
sequent lines until you send the <ESC>R command. The
Total Reset command will also terminate Uncierscoring.
I
<ESC>RI
UNDERSCORE "OFF'
This command terminates the Underscore Mode.
An
<ESC>X also terminates the Underscoring command; how-
ever, this command will also cancel all other word pro-
cessing commands except Proportional Spacing at the same
time.
I
<ESC>O
I
BOLD PRINT "ON"
The Bold Print "ON" command causes each printable char-
acter to be printed twice. The print position is moved 1
dot down for the second printing of the character. A Car-
riage Return, <ESC>& or <ESC>X will exit the Bold Print
Mode. Remember, <ESOX will cancel all other word
processing options except Proportional Spacing.
I
<ESC>&
I
BOLD/SHADOW PRINT "OFF"
This command may be used to terminate both Bold and
Shadow Print Modes.
I
<Esc>wl
SHADOW PRINT "ON"
The Shadow Print "ON" command causes each printable
character to be printed twice. The print position is moved
1 dot horizontally for the second printing of the character.
This results in a slightly wider or thicker character. A Car-
riage Return, <ESC>& or <ESC>X will terminate Shadow
Print Mode. Remember, <ESC>X will cancel all other
.4
word processing options except Proportional Spacing.
[~
0-28
Diablo Emulation Mode
Advertisement
Table of Contents
