Table of Contents
Advertisement
Remote Diagnostic Options
<ESC><SUB>I
Initialize the Printer
<ESC><SUB>R
Remote Error Reset
<ESC><SUB>2
Request Status Byte 2
<ESC><SUB>U
Enter User (programmable) Test Mode
<ESC><SUB>W Enter Wrap-around (Echo) Test Mode
<ESC><SUB>X
Exit Test Mode
<DEL>
Error Correct Backspace
(User Test Mode Only)
<STX>
Print Contents of Print Buffer
once (User Test Mode Only)
<SOH>
Print Contents of Print Buffer
repeatedly (User Test Mode Only)
C
Supported Diablo Commands
The commands which are supported by the printer are
described on the following pages. If you have files that
already contain Diablo commands, you need not make
any changes to these files before sending them to the laser
printer. Any Diablo commands that are not supported by
the printer will be absorbed and will not interrupt printing.
C.I
Single Character Commands
Single character commands consist of only one control
character. The commands in "<>" are ASCII control char-
acters. You must refer to "Software Commands" in Sec-
tion 4 for information on embedding control characters.
• BACKSPACE «BS» moves the current position one
space in the opposite direction of printing.
• CARRIAGE RETURN «CR» moves the current po-
sition to the Left Margin.
• FORM FEED «FF» ejects the current page from the
D-6
Diablo Emulation Mode
/
Advertisement
Table of Contents
