QMS SmartWriter 80+ User Manual page 266

Special Printer Features
<BS> Backspace
<ESC» Set High-Order Bit "ON"
<ESC>= Set High-Order Bit "OFF"
<ESC># Accept High-Order "as is" from com-
puter
<ESC>R Select International Character Set
Formatting Commands
<ESC>1 Set Left Margin
<ESC>Q Set Right Margin
<ESC>D Set Horizontal Tabs
<HT> Horizontal Tab
<ESC>B Set Vertical Tabs
<VT> Vertical Tab
<ESC>bx Define Vertical Tab Channels
<ESC>! Select Vertical Tab Channel
Graphics Modes
<ESC> K Selects Single-Density Graphics Mode
<ESC>L Selects Double-Density Graphics Mode
<ESC> Y Selects High Speed Double-Density Mode
<ESC>Z Selects Quadruple-Density Graphics Mode
<ESC>* Selects Graphics Density "n"
<ESC>% Select Character Set
<ESC>& Define Characters in RAM Area (Down-
load Font)
<ESC>: Copy ROM Characters to User RAM
Area
<ESC>I1 Enable Printing of the Symbols that are
not stored in 0-31 decimal which are not
used as Control Codes.
<ESC>IO Disable Printing of the Symbols that are
not stored in 0-31 decimal which are not
used as Control Codes.
<ESC>6 Enables Printing Codes 128 - 159 deci-
mal
<ESC> 7 Disable Printing Codes 128 - 159 deci-
mal
E-4 Appendix E