Table of Contents
Advertisement
C.4
Automatic Font Selection
If you do not specify a particular font, the printer is de-
signed to select one automatically. The font that the printer
would select in such a case depends on the current emula-
tion mode. If the printer is in Diablo or Qume emulation
\
mode, it is designed to select either the power-up portrait
font (Group P Options) or the power-up landscape font
(Group L Options) depending on which page orientation
is being used.
If you are using Epson emulation mode, the printer is
designed to select the "Epson Pica" font (font number 382)
regardless of the font specified by the Group P or Group
L Options. If you are using Proprinter emulation mode,
the printer is designed to select the "Proprinter Pica" font
(font number 385) regardless of the font specified by the
Group P or Group L Options.
If you use the Group C Options while in Diablo or Qume
emulation mode and then switch the printer to Epson emu-
lation mode, the printer is designed to automatically select
the "Epson Pica" font and ignore the font you were using.
(NOTE:
Group E Option A allows you to prevent the
printer from selecting the Pica font when Epson emulation
mode is accessed. Group I Option 5 allows you to prevent
the printer from selecting the Pica font when Proprinter
emulation mode is accessed.)
D
Diablo Emulation Options
(Group
D)
The Options in Group D only affect the printer when it is
in Diablo emulation mode.
Toggle Option 0 of any Group to save changes to
Printer Setup.
t=
Factory setting
3-20
Printer Setup
Advertisement
Table of Contents
