Table of Contents
Advertisement
I
<ESC>61 SELECT CHARACTER SET 2
This command selects Character Set 2. Character Set 2
contains characters and symbols used in non-English lan-
guages. <ESC>6 overrides Group E Option 3.
I
<ESC>71 SELECT CHARACTER SET 1
This command selects Character Set 1. Character Set 2
contains characters and symbols commonly used in En-
glish. <ESC>6 overrides Group E Option 3.
I
<ESC>\<nl><n2>
I
~~iN~if:I~~~~¥~IJk~OM
This command allows the printing of all characters, in-
cluding special symbols assigned to ASCII values below
decimal 32 (normally recognized as control codes). This
command can also be used to print characters between
128-159 (for Character Set 1). A Space character prints
for each unassigned character sent.
<n2>
=
number of 'groups' of 256 characters
<nl>
=
number of single characters
Total number of characters
=
<nl>
+
«n2> x 256).
I
<ESC>
A
I
PRINT SINGLE CHARACTER FROM ALL
. CHARACTERS CHART
This command prints one character from the All Charac-
ters Chart. This command can be used to print characters
assigned to ASCII values normally recognized as control
codes. (See <ESC> \)
F-26
Proprinter Emulation Mode
Advertisement
Table of Contents
