Table of Contents
Advertisement
2. Clean the four corner depressions on the bottom of the switch enclosure, place
3. Place the switch on a flat, sturdy surface.
4. Provide power to the switch as described in "Providing power to the switch"
Attention:
correctly set. For instructions on how to cable and configure the switch, and how
to set the IP address, see "Cabling and setting up the switch" on page 14.
Installing in an EIA cabinet
Attention: Refer to "Rack safety" on page xix for danger and caution notices
related to rack and cabinet installations.
You can install the rack mount kit in only one way in a cabinet, with the port side
of the switch able to slide out of the exhaust-air side of the cabinet. In this
installation, the port side of the switch is flush with the edge of the cabinet.
Time required
Approximately 30 minutes, not including configuration.
Items required
You need the following items to install the switch in a slide-rail rack:
v Straight slot screwdriver
v Rack space: 1U of rack space
v Two power cables that are provided with the switch
v Two power outlets
v Rack mount kit
Attention: Use the exact screws specified in the procedure for use with the switch
chassis. Using screws longer than 3/16 in. can damage the switch. The different
types of screws are listed in Table 5 on page 10. Make sure that you tighten all
screws used in this procedure.
Installation instructions
To install the switch in a slide-rail rack that meets EIA standards, use the following
procedure.
Note: These procedures use parts that are included in the rack-mount kit. These
Before you start the rack-mount installation process, locate the rack-mount slides
and the mounting bracket that are provided in the shipping container.
Figure 4 on page 10 shows the rack assembly. The number keys, such as 1 , refer
to the items listed in Table 5 on page 10.
an adhesive rubber foot in each one, and firmly press into place. The rubber
feet on the switch help prevent the switch from sliding off the supporting
surface.
on page 16.
Do not connect the switch to the network until the IP address is
parts are listed in Table 5 on page 10. The installation procedure
cross-references the items in this table. Be sure to use the referenced parts
when you perform each step.
Chapter 2. Installing and configuring the SAN06B-R
9
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
