SJ002016
Figure 92. Power cord cabling (rack side view)
Attention: To ensure proper air circulation and cooling, filler panels (see "Blank fillers" on page 224)
must be installed in all blank spaces in the rack.
Step 10. Connect switch and device cables
The factory configures the rack and installs all of the director power cables.
The factory does not install switches or routers. These products should be installed only by qualified
personnel.
If you need to install device cables, follow the installation instructions provided with the component that
you are installing.
Step 11. Power on the rack
Perform the following steps to power on the rack:
1. Plug all power cords into the outlets on the power distribution units (iPDUs).
2. Plug the power cord of each iPDU into the customer's ac power outlets. Use only the cords supplied
with the rack and iPDUs.
217
Appendix A. SAN rack