Jam Nut
Leveling Screw
Front of Cabinet
Figure 84. Adjusting the leveling feet
Step 3. Attach the stabilizers
DANGER
1. Align the slots in the stabilizer with the mounting holes at the bottom front of the rack. See Figure 85.
Mounting Hole
Mounting Screw
Stabilizer
Figure 85. Stabilizers
2. Install the two mounting screws.
3. Ensure that the base of the stabilizer rests firmly on the floor. Use the Allen wrench that is supplied
with the rack to alternately tighten the mounting screws until they are tight.
4. Repeat step 1 through step 3 to install the stabilizer at the bottom rear of the rack.
Rear of Cabinet
You must firmly attach the stabilizers to the bottom front and bottom rear of the rack
to prevent the rack from turning over when the switches are pulled out of the rack.
(R001)
Front of Cabinet
Rear of Cabinet
SJ000655
Mounting Screw
Allen Wrench
SJ000656
209
Appendix A. SAN rack