Chassis door
This topic provides the following information:
v "Chassis door overview"
v "Time and items required"
v "Removing a chassis door"
v "Installing a chassis door"
Chassis door overview
The chassis door must be installed to ensure that the device meets EMI and other regulatory
certifications. A receiving hole is located on each corner on the back side of the door. Each hole snaps into
a ball stud located on a matching corner of the chassis.
Time and items required
The first-time installation procedure for the chassis door takes 15 minutes or longer because you must
remove the protective cover and install ball studs to mount the door. Thereafter, removal and
reinstallation should take less than 5 minutes.
Required for installation are the door assembly, packaged separately from the chassis, and ball studs for
the door. Ball studs are packaged with the door assembly.
Removing a chassis door
Support the door to prevent it from falling. Pull and remove the door. It will pop off the ball studs.
Figure 78. Removal and replacement of the chassis door
Installing a chassis door
About this task
Complete the following steps to install the door on the port side of the chassis.
187
© Copyright IBM Corp. 2018