Table of Contents
Advertisement
Table 5. Tasks overview (continued)
Task
Preparing to move the FAStT900
Storage Server
Removing and replacing the front bezel to access the FAStT Storage
Server components
To access the controller blades, battery, storage server fan, and indicator lights, you
must remove the FAStT900 Storage Server bezel, as shown in Figure 21.
Attention:
To avoid damaging the hooks, place the FAStT900 Storage Server on a flat surface.
Be sure the front of the FAStT900 Storage Server extends beyond the edge
approximately 5 cm (2 in.).
1. Carefully pull the bottom of the bezel out to release the pins. Then slide the
Figure 21. Removing the FAStT900 Storage Server bezel
2. To replace the bezel, slip the top edge of the bezel under the lip on the chassis,
16
IBM TotalStorageFAStT900 Fibre Channel Storage Server: User's Guide
Description
You might need to move the
FAStT900 Storage Server to a new
location or remove the chassis from
its rack cabinet.
Pulling the cover out too far can damage the plastic hooks at the top.
bezel down as shown in Figure 21.
then push the bottom of the bezel until the pins snap into the mounting holes,
as shown in Figure 22 on page 17.
See
"Preparing to move the FAStT900
Storage Server" on page 33
Advertisement
Table of Contents
