Upnp Config - THOMSON SpeedTouch 608 Cli Reference Manual

UPnP Commands

upnp config

Configure UPnP™ parameter(s).
SYNTAX:
upnp config
where:
maxage
defcservice
writemode
safenat
preferredaddress
462
[maxage = <number{60-999999}>]
[defcservice = <string>]
[writemode = <{full|natonly|readonly}>]
[safenat = <{disabled|enabled}>]
[preferredaddress = <ip-address>]
This parameter allows to configure how often the SpeedTouch™
sends a notification message to advertise its presence as an Internet
Gateway Device IGD) on the network.
Setting this parameter to a low value will increase the number of
packets sent over time on the network, but will make the state of
the device more up to date.
The default is 1800.
This parameter allows to configure the connection service to be
used by the DrSpeedTouch™ application during the troubleshooting
process (only when several connection services are configured on
the SpeedTouch™, else only the default connection service).
Choose the set of rules to limit remote access from UPnP.
Choose between:
•
full: the host will accept all the UPnP SET and GET actions.
•
natonly: GET and NAT related SET actions will be accepted, all
other actions will be ignored.
•
readonly: the UPnP control point will only be able to retrieve
information, all the SET actions are ignored.
Enable / disable check on safe NAT entries.
If this check is enabled, all NAT create/delete requests for a LAN
side IP address different from the source IP address of the UPnP
message will be discarded.
Preferred ip address for UPnP advertisements (enter 0.0.0.0 for
none).
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040216-0002 v1.0