THOMSON SpeedTouch 608 Cli Reference Manual page 237

priority
realtimerate
burstsize
weight1
weight2
weight3
weight4
maxpackets
maxbytes
EXAMPLE:
=>ipqos config dest=PVC_1 state=enabled discard=early priority=wfq
=>ipqos list
Name State Discard
PVC_1 enabled early
=>
RELATED COMMANDS:
ipqos list
E-DOC-CTC-20040216-0002 v1.0
Select the queue scheduling algorithm. Choose between:
•
wfq:
Weighted Fair Queueing (WFQ) is used for the middle four queues.
The realtime queue has priority over the WFQ queues, which have
priority over the best-effort queue.
•
strict:
Priority queueing is used.
Strict Priority scheduling is used between all queues. The higher the
queue number, the higher the priority.
The default iswfq.
A number between 1 and 100.
Represents a percentage of the interface bandwidth for rate-limiting of
the Real Time queue.
In case of congestion, the Real Time queue will only use this percentage of
the interface bandwidth when there is also traffic on the other queues.
The default is 80.
A number between 1 and 128.
Represents the realtime queue burstsize (in kilobytes) for rate limiting.
A number between 1 and 97.
Represents the weight of queue 1 used for WFQ. The default is 25 (%).
A number between 1 and 97.
Represents the weight of queue 2 used for WFQ. The default is 25 (%).
A number between 1 and 97.
Represents the weight of queue 3 used for WFQ. The default is 25 (%).
A number between 1 and 97.
Represents the weight of queue 4 used for WFQ. The default is 25 (%).
A number between 0 and 100.
Represents the maximum number of packets in all IP QoS queues
instantiated for one interface.
A number between 0 and 128.
Represents the maximum size in kilobytes in all IP QoS queues
instantiated for one interface.
Priority Packets
wfq 0
List IP QoS configuration.
Kbytes Rate Burstsize
0 80% 2
IPQoS Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
Weights
25% 25% 25% 25%
235