THOMSON SpeedTouch 608 Cli Reference Manual page 299

prot
srcport
srcportend
dstport
dstportend
clink
log
policy
E-DOC-CTC-20040216-0002 v1.0
The protocol (name or number) expected [or NOT expected] in the
IP packet.
Select one of the following protocol names:
•
icmp
•
igmp
•
ipinip
•
tcp
•
udp
•
ah
•
esp
•
ipcomp
or, alternatively, specify the protocol number.
The TCP/UDP port (or beginning of range) the packet should [or
should NOT] be from.
Select one of the supported TCP/UDP port names (See
TCP/UDP Port Names" on page 480
names supported by the SpeedTouch™ ).
Alternatively, specify the protocol number.
The source TCP/UDP port range end (inclusive) (only applicable for
ranges).
Select one of the supported TCP/UDP port names (See
TCP/UDP Port Names" on page 480
names supported by the SpeedTouch™ ).
Alternatively, specify the protocol number.
The TCP/UDP port (or beginning of range) the packet should [or
should NOT] be going to.
Select one of the supported TCP/UDP port names (See
TCP/UDP Port Names" on page 480
names supported by the SpeedTouch™ ).
Alternatively, specify the protocol number.
The destination TCP/UDP port range end (inclusive) (only applicable
for ranges.)
Select one of the supported TCP/UDP port names (See
TCP/UDP Port Names" on page 480
names supported by the SpeedTouch™ ).
Alternatively, specify the protocol number.
The name of the (sub)chain to be parsed when this rule applies.
(action should be link).
Generate syslog message for each packet dropped, denied, or
accepted by applying it to this rule.
The connection profile name.
Represents the name of the policy to which this rules applies.
Specify 'none' to indicate traffic to be sent to the clear or link.
" Supported
for a listing of TCP/UDP port
" Supported
for a listing of TCP/UDP port
" Supported
for a listing of TCP/UDP port
" Supported
for a listing of TCP/UDP port
IPSec Commands
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
REQUIRED
297