Eth Config - THOMSON SpeedTouch 608 Cli Reference Manual

Eth Commands

eth config

Enable/disable the Ethernet interface.
SYNTAX:
eth config
where:
intf
state
EXAMPLE:
=>eth config
ETH Intf 1 port state = UP [forwarding]
ETH Intf 2 port state = UP [forwarding]
ETH Intf 3 port state = UP [forwarding]
ETH Intf 4 port state = UP [forwarding]
=>eth config intf=4 state=disabled
=>eth config
ETH Intf 1 port state = UP [forwarding]
ETH Intf 2 port state = UP [forwarding]
ETH Intf 3 port state = UP [forwarding]
ETH Intf 4 port state = DOWN [disabled]
=>
RELATED COMMANDS:
eth iflist
156
intf = <number {1-4}>
[state = <{enabled|disabled}>]
The Ethernet interface to be configured.
Enable or disable the Ethernet interface.
The default is enabled.
Show Ethernet port configuration and current operating mode.
REQUIRED
OPTIONAL
E-DOC-CTC-20040216-0002 v1.0