Ipqos Queue Config - THOMSON SpeedTouch 608 Cli Reference Manual

IPQoS Commands

ipqos queue config

Configure IP QoS subqueues.
SYNTAX:
ipqos queue config
where:
dest
queue
propagate
maxpackets
maxbytes
238
dest = <string>
queue = <number{0-5}>
[propagate = <{disabled|enabled}>]
[maxpackets = <number{0-100}>]
[maxbytes = <number{0-128}>]
The destination interface for the IP QoS queues instantiation.
Typically, a phonebook entry.
A number between 0 and 5.
Represents the number of the queue, where:
•
5 is the Real Time queue
•
4 is WFQ4
•
3 is WFQ3
•
2 is WFQ2
•
1 is WFQ1
•
0 is the Best Effort queue.
Higher priority packets will be queued in a lower priority queue, instead
of being dropped, as soon as the destination queue is in overflow state.
The packet will be put in a lower priority queue only once.
Choose between disabled or enabled.
The default is disabled.
The propagate flag for the lowest priority subqueue
Note
(the Best Effort queue) has no meaning.
A number between 0 and 100.
Represents the maximum number of packets in this queue.
A number between 0 and 128.
Represents the maximum size in kilobytes of this queue.
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040216-0002 v1.0