Systemlog Send - THOMSON SpeedTouch 608 Cli Reference Manual

systemlog send

Send syslog messages from the internal SpeedTouch™ Syslog message buffer to a specified local or remote syslog
server host.
SYNTAX:
systemlog send
where:
fac
sev
hist
dest
There will be no notification on whether the host has received the messages or not.
Note
E-DOC-CTC-20040216-0002 v1.0
[fac = <supported facility name>]
[sev = <supported severity name>]
[hist = <{no|yes}>]
dest = <ip-address>
Specify the facility name of the syslog messages to show.
Use one of the supported facility names (See
Facilities" on page 484 for a listing of syslog facility names supported
by the SpeedTouch™).
If not specified, the messages of all the facilities will be shown.
Specify the lowest priority severity of the syslog messages to show.
Specifying a severity actually means specifying to show the syslog
messages with a severity as specified, and all messages with a higher
severity.
Use one of the supported severity names (See
Severities" on page 485 for a listing of syslog facility names
supported by the SpeedTouch™).
The show messages over several SpeedTouch™ reboots (yes) or
show only messages since latest startup (no).
The IP address of the remote host on the local or remote network,
i.e. the collector's IP address, to send the syslog messages to.
Systemlog Commands
" Supported Syslog
" Supported Syslog
OPTIONAL
OPTIONAL
OPTIONAL
REQUIRED
457