THOMSON SpeedTouch 608 Cli Reference Manual page 381

idletrigger
addrtrans
unnumbered
EXAMPLE:
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 1)
user name = My_Connection@MY_ISP
admin state = down
LCP: state = initial
IPCP: state = initial
=>pppoe ifconfig intf=PPPoE1 encaps=vcmux
=>pppoe iflist
PPPoE1: dest : PPPoE1
Retry: 10 QoS
mode = IP Routing
flags = echo magic
trans addr = pat
route = 0.0.0.0/0 - 0.0.0.0/0 (metric 1)
user name = My_Connection@MY_ISP
admin state = down
LCP: state = initial
IPCP: state = initial
=>
RELATED COMMANDS:
pppoe ifadd
pppoe ifattach
pppoe ifdelete
pppoe ifdetach
pppoe iflist
E-DOC-CTC-20040216-0002 v1.0
Consider the link being idle if no traffic is sent and/or received during the
idle time. Choose between:
•
RxTx: The idle time period restarts when a packet is transmitted or
received.
•
Rx: The idle time period restarts when a packet is received.
Transmitted packets are ignored.
•
Tx: The idle time period restarts when a packet is transmitted.
Received packets are ignored.
The default is RxTx.
Automatically enable address translation for the IP address of this link
(pat) or do not use address translation (none). The default is none.
Takes the local IP address from the laddr field and remote IP address from
the IP address pool assigned to the incoming PPPoE link.
In case the unnumbered parameter is disabled, the same IP address is
used for each connection on the server side, thus reducing the number of
used IP addresses.
default encaps
accomp restart mru
mru = 1492
password = ********
oper state = down
retransm = 10
retransm = 0
default encaps
accomp restart mru
mru = 1492
password = ********
oper state = down
retransm = 10
retransm = 0
Create a new PPPoE interface.
Attach a PPPoE interface.
Delete a PPPoE interface.
Detach a PPPoE interface.
Show current PPPoE configuration.
LLC
addr route savepwd
link state = not-connected
term. reason =
term. reason =
VC-MUX
addr route savepwd
link state = not-connected
term. reason =
term. reason =
PPPoE Commands
OPTIONAL
OPTIONAL
OPTIONAL
PPPoEOA
PPPoEOA
379