Ip Ifconfig - THOMSON SpeedTouch 608 Cli Reference Manual

IP Commands

ip ifconfig

Configure IP interface parameters.
SYNTAX:
ip ifconfig
where:
intf
mtu
status
hwaddr
group
linksensing
EXAMPLE:
=>ip iflist
Interface GRP MTU
0 loop 1 1500
1 eth0 2 3000
2 ETHoA 0 1500
5 cip0 0 9180
=>ip ifconfig intf=eth0 mtu=1500
=>ip iflist
Interface GRP MTU
0 loop 1 1500
1 eth0 2 1500
2 ETHoA 0 1500
5 cip0 0 9180
=>
RELATED COMMANDS:
ip config
204
intf = <interface name>
[mtu = <number{68-20000}>]
[status = <{down|up}>]
[hwaddr = <hardware-address>]
[group = <{wan|local|lan}> or number]
[linksensing = <{off|on}>]
The IP interface name.
A number between 68 and 20000.
Represents the maximum transmission unit, i.e. the maximum packet size
(including IP header) to use on this interface.
The default value depends on the connection and packet service for which
the interface was created.
The administrative status of the interface.
Choose between:
•
down
•
up.
The hardware address (e.g. the Ethernet MAC address) of this IP interface.
The group to which this interface belongs (e.g. for oriented firewalling).
The IP interface's awareness of link state transitions.
RX TX TX-DROP
116 0 0
21045795 1019664 0
0 0 0
0 0 0
RX TX TX-DROP
116 0 0
21054963 1025417 0
0 0 0
0 0 0
Show/set global IP stack configuration options.
STATUS HWADDR
UP
UP 00:80:9f:24:ab:cf
UP 00:80:9f:24:ab:cf
UP
STATUS HWADDR
UP
UP 00:80:9f:24:ab:cf
UP 00:80:9f:24:ab:cf
UP
REQUIRED
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
OPTIONAL
E-DOC-CTC-20040216-0002 v1.0